![]() I cloned my boot drive a month ago and the clone haven't been online since. FanControl doesn't view this as errors, nor does it give any indication to what might be wrong. This would indicate that I somehow corrupted a setting, but I disabled starting at startup, rebooted and started with a fresh v111 and it still didn't work. ![]() Downgrading to v111 didn't fix the problem, nor did rebooting. GPU fan control seems fine though.Īuto pairing obviously doesn't work, but auto pairing and threshold setup worked earlier this week (v111). I have opened the computer and verified that the CPU fan does indeed stop.Ĭase fan control is dead in another way. Occationally it spikes for a single reading before stopping, like going 800-1100-0 RPM when it was supposed to drop to like 500 RPM. I even tried a flat curve at 50% and this went to 0 rpm even when the system set it at 47-52%. When enabling it jumps to 0 rpm within 1-2 updates regardless of selected curve. When the CPU fan is disabled, the system takes over and it reports RPM as expected. It asked if I wanted to upgrade to v112 and I clicked ok, it restarted and now the fan controllers can't be controlled. You are receiving this because you were mentioned.I had a setup with v111, which worked as expected. Then watch your fans IRL as you slide each to figure out which is which. Just assign a curve to the appropriate control, it should work. On Jun 3, 2022, at 12:41 PM, Rem0o wrote:īut you mentioned the fans stopped during detection right? Don't bother with the speed cards with RPM, or any of the "detected" stuff from the assisted setup. You are receiving this because you were mentioned.Message ID: from my iPhone If you can see your fans changing speed, then you're all good. On Jun 3, 2022, at 7:20 AM, Rem0o That's because since you got multiple fans on the same channel, the RPM detection is bust, so it can't rely on it. ![]() You are receiving this because you authored the thread.Message ID: from my iPhone ![]() Reply to this email directly, view it on GitHub, or unsubscribe. And is the Mobo Controller set to the Right DC or PWM Control on SYS_Fan 1 corresponding to your Fans Ans what Connection do ther Use 3 Pin DC Control or 4 Pin Pwm Control. ![]() On Jun 3, 2022, at 7:13 AM, Audipower wrote:Ĭan you Control this Fans with the Mobo Settings in Bios ? Some Case fans are 1 Speed Only. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |